Authentic NACE NACE-CIP1-001 Exam Dumps PDF – Mar-2026 Updated [Q57-Q73]

Q57. On a blast-cleaned surface, Ian ultraviolet light is generally used to detect

Q58. Using SSPC Vis 1 as a guide when performing a visual inspection of a steel surface prior to surface preparation a NACE Inspector would assign which designations to the surface condition:

Q59. As a NACE Coating Inspector your responsibility with respect to safety is to:

Q60. Which is a component that supplies most of the features and functions of the material?

Q61. If the project specification DOES NOT state the specific DFT measurement standards, the inspector should use

Q62. You are the NACE Inspector on a job where the Owner’s specification requites you to perform a twice daily check of blast pressure at the nozzle. It is now day 30 on the job and all of your readings have been within compliance. The Contractor complains that these checks taking up much time and in view of the compliant results they are unnecessary.
Your FIRST preferred course of action is to:

Q63. Silicone coatings are typically:

Q64. You ate the NACE Inspector on a job where NACE No. 2/SSPC – SP 10 has been specified. You are finding the Contractor is leaving mill scale on the on surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in be in compliance with the standard.
Your FIRST preferred course of action is to:

Q65. When using a sling physchrometer a very large difference between the wet and dry bulb readings indicates:

Q66. An exposed area of the substrate or previous coat of a conductive coating material, often caused by poor application technique is called

Q67. The Inspector’s Log Book is generally:

Q68. It is good practice for the NACE Inspector to have instrument calibration certificates available:

Q69. ISO SA 3 is directly equivalent to:

Q70. You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining.
Your FIRST preferred course of action is to:

Q71. Check abrasive blast pressure close to the

Q72. The initial steel condition is important to the NACE Inspector because:

Q73. To be of value the Inspector’s documentation must be: