H35-480_V3.0 Exam Dumps Pass with Updated Apr-2023 Tests Dumps [Q36-Q60]

Q36. Which of the following signals is measured by a 5G UE to report channel quality information such as the CQI, RI, and PMI to a gNodeB?

Q37. Which of the following files must be prepared when remotely commissioning a gNodeB using the MAE Deployment? (Choose All that Apply)

Q38. Which of the following NR channels or signals supports static and dynamic power control?

Q39. According to 5G eMBB service requirements, which of the following is the minimum rate required for network edge coverage?

Q40. What is the maximum MIMO mode supported by Huawei 5G indoor CPE?

Q41. On an NSA network, the eNodeB immediately triggers the SgNB addition procedure after a UE attaches to the LTE network. If the SgNB addition fails, the eNodeB attempts to add the SgNB again until it is successful.

Q42. Which of the following functions are implemented by the UBBP board in the BBU5900? (Choose all that Apply)

Q43. During a 5G service test, an NSA UE connects to the Probe and then accesses a 4G cell. It is found that the cell does not deliver B1measurement configurations. Which of the following is not a possible cause for this?

Q44. During a 5G service test, an NSA UE connects to the Probe and then accesses a 4G cell. It is found that the cell does not deliver B1 measurement configurations. Which of the following is not a possible cause for this?

Q45. On an NSA network, the eNodeB immediately triggers the SgNB addition procedure after a UE attaches to the LTE network. If the SgNB addition fails, the eNodeB attempts to add the SgNB again until it is successful.

Q46. In what scenarios is GENEX Assistant typically applied?

Q47. Which type of information about NR cells is carried in the neighboring NR cell MRs reported by UEs? (Choose all that Apply)

Q48. After the cell search is complete, a 5G UE automatically selects a PLMN based on the priority sequence. Which PLMN will the UE preferentially select for registration?

Q49. The RSRP value of the test terminal can be viewed on the GENEX Probe. Which of the following test results indicate good signal quality?

Q50. 5G inherits the frame structure of 4G, but the slot length can be adjusted based on different SCSs. Which of the following is not a 5G slot length?

Q51. F-OFDM over the NR air interface uses flexible subcarrier spacing to meet the requirements of different 5G service scenarios. Which of the following types of subcarrier spacing is not supported by Sub6G?

Q52. E2E network device update is required for the evolution from 5G NSA networking to SA networking.

Q53. During a 5G test, a portable computer is directly connected to the LAN port of the Huawei CPE through a network cable to obtain a dynamic IP address for communication.

Q54. The BBU5900 uses a modular design. Which of the following subsystems constitute the BBU? (Choose All that Apply)

Q55. According to 5G eMBB service requirements, which of the following is the minimum rate required for network edge coverage?

Q56. At which layer is downlink data split implemented over the NR air interface in the NSA Option 3x architecture?

Q57. In SA networking, the mobile country code (MCC) and mobile network code (MNC) information added on the gNodeB must be consistent with the PLMN information on the core network.

Q58. According to 3GPP specifications, which of the following is not an RRC state in 5G?

Q59. Which of the following actions are involved in NAS procedure management in 5G?

Q60. C-band is the most popular frequency band for 5G network deployment. However, there is an imbalance between uplink and downlink coverage – how much does this imbalance approximately amount to?