[Jun 18, 2023] Uplift Your NS0-520 Exam Marks With The Help of NS0-520 Dumps [Q113-Q127]

Q113. A customer has an AFF A700 connected to a Cisco switch and has verified connectivity but cannot see any LUNs. The customer issued the run -node scaling-01 -command fcp topology show command to verify the connection.
Referring to the exhibit, what needs to be enabled on the Cisco switch?

Q114. An administrator is testing a newly deployed SAN configuration and wants to simulate a node failure by administratively taking all FC physical ports down on a node that is serving data.
In this scenario, what should the administrator observe?

Q115. Which two are supported in ONTAP 9.5? (Choose two.)

Q116. After the addition of extra DS224C disk shelves, you notice that the output of the system node run -node node_1 sysconfig command shows Mixed-path. You need to investigate why the additional shelves are providing this error.
In this scenario, which two tools would help diagnose this issue? (Choose two.)

Q117. You are configuring both NVMe and FC on the same AFF A700 2-node ONTAP 9.5 cluster. You are also configuring both protocols on the same FC fabric using the same A700 HBA ports.
In this scenario, which three configurations are supported? (Choose three.)

Q118. You have deployed a FAS8300 system and wait to enable SAN protocols. In this scenario, which two protocols are available to serve SAN data? (Choose two)

Q119. You have a LUN owned by Node 01 and mapped using the default Selective LUN Map (SLM) configuration. You want to enable your host to access this LUN and facilitate future maintenance.
Which best-practice zone configuration accomplishes this task?

Q120. An ONTAP administrator is troubleshooting a fabric login issue with a client. The SVM in question uses both FC and NFS protocols.
In this scenario, what would be the least disruptive operation?

Q121. An administrator suspects abnormal operation and performance-related issues within a particular SAN environment. The administrator wants to further investigate the environment in terms of overall health, best practice recommendations, proactive remediation, and risk assessments, as compared to other SAN deployments.
Which tool should the administrator use to assess this information?

Q122. An administrator configures NVMe within an SVM for a test environment. The administrator creates an NVMe namespace and an NVMe subsystem. The administrator then maps the namespace to the subsystem. However, when the administrator establishes a connection to a supported host, the following error message appears: No discovery log entries to fetch.
What is the solution to this error?

Q123. You are asked to separate production FC traffic from test development FC traffic. In this scenario, at a minimum, which two configurations would accomplish this task? (choose two)

Q124. You have finished deploying a Netapp AFF All SAN Array Cluster and want to test the persistent ports feature. In this scenario, how would you accomplish this task?

Q125. You are testing iSCSI LUN failover across a 4-node FAS9000 fabric-attached MetroCluster configuration.
In this scenario, which front end configuration is required for non-disruptive host LUN failover between sites?

Q126. You have an SVM serving LUNs to your VMware environment. You have configured the SAN LIFs, zoning, and multipath by using industry best practices. You need to temporarily migrate a SAN LIF to another host, preserving the SAN LIF’s WWPN. You do not want to lose access to the LUNs during LIF migration.
In this scenario, what are three required steps that are needed to accomplish this task? (Choose three.)

Q127. An administrator has taken over managing an AFF A320 4-node SAN environment with several attached hosts. The administrator is asked to inventory the environment before performing firmware updates.
In this scenario, which two tools would satisfy the requirement? (Choose two.)