Get Instant Access to D-NWG-FN-23 Practice Exam Questions [Q20-Q43]

5/5 - (2 votes)

Get Instant Access to D-NWG-FN-23 Practice Exam Questions

Reliable Study Materials & Testing Engine for D-NWG-FN-23 Exam Success!

QUESTION 20
To which IEEE standard are dynamic LAGs compliant on Dell EMC Networking OS10 switches?

802.3af

802.3ad

802.3ac

802.3ae

QUESTION 21
Two OS10 switches reside within a VLT domain with statically configured primary-priorities. The current primary peer, switch OS10-A, has a priority of 100, while the secondary peer, OS10-B, has a priority of 200.
If OS10-A reboots and comes back online, what roles will the VLT peers be assigned?

OS10-A will be primary and OS10-B will be secondary.

OS10-A will be secondary and OS10-B will be master.

OS10-A will be standby and OS10-B will be primary.

OS10-A will be secondary and OS10-B will be primary.

QUESTION 22
Which configuration supports tagged frames on VLAN 20 and untagged frames on VLAN 5?

interface ethernet 1/1/9
switchport trunk mode allowed vlan 20 switchport access mode vlan 5 no shutdown

interface ethernet 1/1/9 switchport trunk allowed vlan 20 switchport access vlan 5 switchport mode trunk

interface ethernet 1/1/9
switchport trunk mode allowed vlan 20 switchport access vlan 5 no shutdown

interface ethernet 1/1/9 switchport mode trunk switchport trunk allowed vlan 20 switchport access vlan 5

QUESTION 23
A network administrator enters the BGP command neighbor 10.0.2.1. The BGP router does NOT have any route to the 10.0.2.0 network. What will happen?

The router will form a successful adjacency with its 10.0.2.1 neighbor. The BGP state will be listed as connect.

The router will not form a successful adjacency with its 10.0.2.1 neighbor.

It will send gratuitous ARP messages to attempt to discover a route to its 10.0.2.1 neighbor.

It will send an ICMP packet to attempt to reach its 10.0.2.1 neighbor.

QUESTION 24
Refer to the exhibit.

Where is the rendezvous point for the group 239.255.255.250?

10.0.13.1

10.0.14.1

eth1/1/54

vlan300

QUESTION 25
An administrator is implementing VLT in OS10. What type of port-channel must they configure for the VLTi?

Administrator needs to configure a LACP Port-Channel.

Trunking and one (1) native VLAN need to be defined on the port-channel.

None, a port-channel is created automatically during VLT discovery.

Administrator needs to configure a static Port-Channel.

QUESTION 26
Which type of protocol is OSPF and what metric does it use to determine best path?

Link-state protocol that uses a concept of cost as metric

Hybrid protocol that uses hop count as a metric

Path vector protocol that uses the Dijkstra algorithm as a metric

Distance Vector protocol that uses bandwidth and delay as metric

QUESTION 27
A network administrator is designing a Layer 2 topology and requires separate spanning-tree roots to avoid having a given port blocked for all instances. Which spanning-tree protocols will meet this need?

STP & RSTP

RSTP-PV & MSTP

STP & RSTP-PV

RSTP & MSTP

QUESTION 28
What is a valid OS10 iBGP configuration?

S2(config)# router bgp 64507
S2(config-router-bgp-64507)# peer-as 64507
S2(config-router-bgp-64507)# neighbor 192.168.32.1 S2(config-router-neighbor)# update-source loopback 0 S2(config-router-neighbor)# no shutdown

S2(config)# router bgp 64507
S2(config-router-bgp-64507)# neighbor 192.168.32.1
S2(config-router-bgp-64507)# remote-as 64507 S2(config-router-bgp-64507)# update-source loopback 0 S2(config-router-bgp-64507)# no shutdown

S2(config)# router bgp 64507
S2(config-router-bgp-64507)# neighbor 192.168.32.1
S2(config-router-neighbor)# remote-as 64507 S2(config-router-neighbor)# update-source loopback 0 S2(config-router-neighbor)# no shutdown

S2(config)# router bgp 64507
S2(config-router-bgp-64507)# remote-as 64507
S2(config-router-bgp-64507)# neighbor 192.168.32.1 S2(config-router-neighbor)# update-source loopback 0 S2(config-router-neighbor)# no shutdown

QUESTION 29
Using the MAC 8c-ec-4b-5b-61-9d, what is a valid EUI-64 link local address?

2001::a9:8eec:4bff:fc5b:619d

fe80::a9:8cec:4bff:fe5b:619d

ff80:a9:8eec:4bff:fe5b:619d

fe80::a9:8eec:4bff:fe5b:619d

QUESTION 30
Which best describes traffic flow in a campus network environment?

North-East

South-West

East-West

North-South

QUESTION 31
What is the valid range of VLAN IDs for Dell EMC Networking OS10 switches?

1-4096

1-4093

0-4092

0-4095

QUESTION 32
Refer to the exhibit.

Which configuration will allow S1 to ping S2’s Lo0 address?

S1(config-router)# ip route 144.254.32.1 192.168.32.2/32

S1(config-router)# ip route 192.168.32.2 144.254.32.1/32

S1(config)# ip route 144.254.32.1/32 192.168.32.2

S1(config)# ip route 192.168.32.2 144.254.32.1/32

QUESTION 33
When configuring VRRP in tandem with VLT, what is the default VRRP mode?

active-active

primary-standby

active-standby

master-backup

QUESTION 34
What are the correct steps to configure a static LAG on a Dell Networking OS10 switch?

interface port-channel 4 channel-group 4 mode passive
interface range ethernet 1/1/14-1/1/15 channel-group 4 mode on

interface port-channel 4 channel-group 4 mode on
interface range ethernet 1/1/14-1/1/15 channel-group 4 mode passive

interface port-channel 4 no shutdown
interface range ethernet 1/1/14-1/1/15 channel-group 4 mode on

interface port-channel 4 no shutdown
interface range ethernet 1/1/14-1/1/15 channel-group 4 mode active

QUESTION 35
Which LSA type provides information necessary to reach routers originating type 5 LSA’s in other areas?

ASBR-Summary (Type 4)

Summary (Type 3)

NSSA (Type 7)

Router (Type 1)

QUESTION 36
The network administrator wants to configure RADIUS authentication for VTY access, and for console access to use the local configuration. Which two commands should be used to achieve this goal?

aaa authentication login vty group radius aaa authentication login console local

aaa authentication login default group radius aaa authentication login console local

aaa authentication login vty radius
aaa authentication login console group local

aaa authentication login default group radius aaa authentication login console group local

QUESTION 37
How are ACLs processed?

LIFO

FIFO

Randomly

Sequentially

QUESTION 38
A customer has disabled LLDP on the management interface of the switch. What is the proper command to re- enable it?

OS10(config)# lldp enable OS10(config)#lldp transmit OS10(config)#lldp receive

OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp med enable OS10(conf-if-ma-1/1/1)#lldp timer 10

OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp transmit OS10(conf-if-ma-1/1/1)#lldp receive

OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp tly-select OS10(conf-if-ma-1/1/1)#lldp dot1tlv

QUESTION 39
How are multiple hardware based ACLs filtered?

NTP

DHCP

NPU

Loading …

EMC D-NWG-FN-23 Exam Syllabus Topics:

Topic	Details
Topic 1	Automation: It introduces network automation capabilities. The sub-topics explain the role and benefits of using Smart Fabric services.
Topic 2	Security Essentials: It covers securing access to network switch, authentication methods, and ACLs. The sub-topics provide the foundation for implementing basic network security.
Topic 3	Networking Essentials: This topic covers various sub-topics like network devices, interface and cabling options, and initial switch configuration. It provides a foundation for understanding how networks operate.
Topic 4	Ethernet Technologies: It discusses Ethernet addressing, LLDP, VLANs, STP, and LAG. The topic also provides key knowledge on the commands to configure and verify LLDP, VLANs, and STP.
Topic 5	Network Services: This topic examines services like DHCP, NTP that provide critical network functionality. The sub-topics focus on deploying and verifying these key services.

Validate your Skills with Updated D-NWG-FN-23 Exam Questions & Answers and Test Engine: https://www.braindumpstudy.com/D-NWG-FN-23_braindumps.html