Guaranteed Accomplishment with Newest Nov-2025 FREE Fortinet NSE7_EFW-7.2 [Q41-Q64]

4/5 - (3 votes)

Guaranteed Accomplishment with Newest Nov-2025 FREE Fortinet NSE7_EFW-7.2

Use Valid New Free NSE7_EFW-7.2 Exam Dumps & Answers

QUESTION 41
Refer to the exhibit, which shows an ADVPN network.

The client behind Spoke-1 generates traffic to the device located behind Spoke-2.
Which first message does the hub send to Spoke-1 to bring up the dynamic tunnel?

Shortcut query

Shortcut reply

Shortcut offer

Shortcut forward

QUESTION 42
Exhibit.

Refer to the exhibit, which contains the partial interface configuration of two FortiGate devices.
Which two conclusions can you draw from this con figuration? (Choose two)

10.1.5.254 is the default gateway of the internal network

On failover new primary device uses the same MAC address as the old primary

The VRRP domain uses the physical MAC address of the primary FortiGate

By default FortiGate B is the primary virtual router

QUESTION 43
Which configuration can be used to reduce the number of BGP sessions in on IBGP network?

Route-reflector-peer enable

Route-reflector-client enable

Route-reflector enable

Route-reflector-server enable

QUESTION 44
Exhibit.

Refer to the exhibit, which shows a partial web filter profile conjuration What can you cone udo from this configuration about access to www.facebook, com, which is categorized as Social Networking?

The access is blocked based on the Content Filter configuration

The access is allowed based on the FortiGuard Category Based Filter configuration

The access is blocked based on the URL Filter configuration

The access is hocked if the local or the public FortiGuard server does not reply

QUESTION 45
Refer to the exhibit, which shows an ADVPN network.

Which VPN phase 1 parameters must you configure on the hub for the ADVPN feature to function? (Choose two.)

set auto-discovery-forwarder enable

set add-route enable

set auto-discovery-receiver enable

set auto-discovery-sender enable

QUESTION 46
After enabling IPS you receive feedback about traffic being dropped.
What could be the reason?

Fail-open is set to disable

Traffic-submit is set to disable

IPS is configured to monitor

Np-accel-mode is set to enable

QUESTION 47
An administrator is configuring two FortiGate devices in an HA cluster. While configuring the devices, the administrator issues the following commands on both HA cluster members:

In which two ways do these commands impact the HA cluster? (Choose two.)

They force the former primary to send gratuitous ARP packets when the failover happens to indicate that the virtual MAC address is now using a different device.

They force the former primary to shut down all its interfaces for one second when failover happens, excluding the heartbeat and reserved management interfaces.

They force both HA devices for remote link monitoring to detect an issue in the forwarding path.

They force the switches to update their MAC forwarding tables, when failover happens.

QUESTION 48
Winch two statements about ADVPN are true? (Choose two)

auto-discovery-receiver must be set to enable on the spokes

Spoke to-spoke traffic never goes through the hub

lt supports NAI for on-demand tunnels

Routing is configured by enabling add-advpn-route

QUESTION 49
Exhibit.

Refer to the exhibit, which contains an ADVPN network diagram and a partial BGP con figuration Which two parameters Should you configure in config neighbor range? (Choose two.)

set prefix 172.16.1.0 255.255.255.0

set route reflector-client enable

set neighbor-group advpn

set prefix 10.1.0 255.255.254.0

QUESTION 50
Which two features are true regarding IPS hardware acceleration? (Choose two.)

cp-accel-iaode advanced option is available only on FortiGate devices that have one or more CP8 processors

set np-access-mode basic will provide last path for IPS inspected traffic

FortiGate does not support IPSA if the cp-accel-mode is configured as none.

Network processors provide pre-IPS anomaly filtering and logging

QUESTION 51
You want to block access to the website ww.eicar.org using a custom IPS signature.
Which custom IPS signature should you configure?

QUESTION 52
Refer to the exhibit, which shows config system central-management information.

Which setting must you configure for the web filtering feature to function?

Add server. fortiguard. net to the server list.

Configure securewf.fortiguard. net on the default servers.

Set update-server-location to automatic.

Configure server-type with the rating option.

QUESTION 53
You want to know which content processor (CP) model FortiGate contains.
Which command should you enter?

get hardware status

diagnose hardware deviceinfo

get hardware cp

diagnose hardware lspci | grep 4e36

QUESTION 54
Refer to the exhibit, which shows an ADVPN network.

Which VPN phase 1 parameters must you configure on the hub for the ADVPN feature to function? (Choose two.)

set auto-discovery-forwarder enable

set add-route enable

set auto-discovery-receiver enable

set auto-discovery-sender enable

QUESTION 55
Exhibit.

Refer to the exhibit, which contains the partial interface configuration of two FortiGate devices.
Which two conclusions can you draw from this con figuration? (Choose two)

10.1.5.254 is the default gateway of the internal network

On failover new primary device uses the same MAC address as the old primary

The VRRP domain uses the physical MAC address of the primary FortiGate

By default FortiGate B is the primary virtual router

QUESTION 56
Refer to the exhibit, which shows a network diagram.

Which IPsec phase 2 configuration should you impalement so that only one remote site is connected at any time?

Set route-overlap to allow.

Set single-source to enable

Set route-overlap to either use-new or use-old

Set net-device to enable

QUESTION 57
Which two statements about IKE version 2 fragmentation are true? (Choose two.)

Only some IKE version 2 packets are considered fragmentable

The reassembly timeout default value is 30 seconds

It is performed at the IP layer

The maximum number of IKE version 2 fragments is 128

QUESTION 58
Refer to the exhibit, which shows a routing table.

What two options can you configure in OSPF to block the advertisement of the 10.1.10.0 prefix? (Choose two.)

Remove the 16.1.10.C prefix from the OSPF network

Configure a distribute-list-out

Configure a route-map out

Disable Redistribute Connected

QUESTION 59
Refer to the exhibit, which shows a custom signature.

Which two modifications must you apply to the configuration of this custom signature so that you can save it on FortiGate? (Choose two.)

Add severity.

Add attack_id.

Ensure that the header syntax is F-SBID.

Start options with –.

QUESTION 60
Refer to the exhibit, which shows two configured FortiGate devices and peering over FGSP.

The main link directly connects the two FortiGate devices and is configured using the set session-syn-dev <interface> command.
What is the primary reason to configure the main link?

To have both sessions and configuration synchronization in layer 2

To load balance both sessions and configuration synchronization between layer 2 and 3

To have only configuration synchronization in layer 3

To have both sessions and configuration synchronization in layer 3

QUESTION 61
Exhibit.

Refer to the exhibit, which contains the partial interface configuration of two FortiGate devices.
Which two conclusions can you draw from this con figuration? (Choose two)

10.1.5.254 is the default gateway of the internal network

On failover new primary device uses the same MAC address as the old primary

The VRRP domain uses the physical MAC address of the primary FortiGate

By default FortiGate B is the primary virtual router

QUESTION 62
Which configuration can be used to reduce the number of BGP sessions in on IBGP network?

Route-reflector-peer enable

Route-reflector-client enable

Route-reflector enable

Route-reflector-server enable

QUESTION 63
Refer to the exhibit.

which contains a partial configuration of the global system. What can you conclude from this output?

NPs and CPs are enabled

Only CPs arc disabled

Only NPs are disabled

NPs and CPs arc disabled

QUESTION 64
An administrator has configured two FortiGate devices for an HA cluster. While testing HA failover, the administrator notices that some of the switches in the network continue to send traffic to the former primary device.
What can the administrator do to fix this problem?

Configure set link-failed-signal enable under config system ha on both cluster members

Configure set send-garp-on-failover enable under config system ha on both cluster members.

Configure remote link monitoring to detect an issue in the forwarding path.

Verify that the speed and duplex settings match between the FortiGate interfaces and the connected switch ports.