[Aug 01, 2026] Fully Updated D-VXR-DY-01 Dumps – 100% Same Q&A In Your Real Exam [Q174-Q193]

Rate this post

[Aug 01, 2026] Fully Updated D-VXR-DY-01 Dumps – 100% Same Q&A In Your Real Exam

Latest D-VXR-DY-01 Exam Dumps – Valid and Updated Dumps

NEW QUESTION 174
In what range does the VxRail Manager Health indicator show “yellow” for IOPS, CPU, and memory usage?

60% – 80%

70% – 80%

75% – 85%

75% – 95%

NEW QUESTION 175
You are configuring a VxRail to connect to an existing, external SRS VE. The customer’s support account is associated with the Site ID/Party ID where VxRail is installed. A validation error is issued when you attempt to register VxRail in SRS.
What is the possible cause for the error?

Wrong IP address was used for SRS VE gateway

Number of deployed devices on SRS gateway has exceeded the maximum

SRS traffic goes through a proxy server

Status of VxRail in Install Base is Shipped

NEW QUESTION 176
Which command will create a daily local backup of the VxRail Manager configuration and important log files?

python /tmp/backup/vxm_backup_restore/vxm_backup_restore.py -c –period daily –keeplog

python /mystic/vxm_backup_restore/vxm_backup_restore.py -b –period daily –keeplog

python /etc/vmware/backup_config/vxm_backup_restore.py -b –period daily –keeplog

python /mystic/vxm_backup_restore/vxm_backup_restore.py -c –period daily –keeplog

NEW QUESTION 177
You have been asked to deploy a single, 4 node VxRail cluster for company. They would like to migrate from their existing vSphere 6.5 environment. They have also asked that vCenter Enhanced linked-mode be supported.
Based on best practice, what is the recommended deployment model?

Use existing vCenter 6.5 with Embedded PSC

Deploy Internal vCenter with External PSC

Deploy Internal vCenter with Embedded PSC

Use existing vCenter 6.5 with External PSC

NEW QUESTION 178
A company has chosen to deploy an external vCenter/PSC. They would like to use the bundled vCenter license that comes with VxRail.
What is the correct procedure to do this?

Contact EMC Licensing to have a replacement vCenter license generated.

Contact VMware Licensing to have a replacement vCenter license generated.

Log into VxRail Manager through SSH and extract the vCenter license key from the application properties file.Next, license the newly created vCenter.

Bundled vCenter license is only valid when vCenter is internally deployed. The company must provide their own vCenter license.

NEW QUESTION 179
How must node ports on Dell EMC ToR switches be configured when the Spanning Tree Protocol is enabled in an environment?

In Port-Channel mode

In Forwarding status

As edge ports

As access ports

NEW QUESTION 180
Use the VxRail simulator to explore the system. What is the presented configuration?
Note: It fs necessary to close (x) the simulator window before you can select a response to this question.

Internal vCenter and external DNS

Internal vCenter and Internal DNS

External vCenter and external DNS

External vCenter and internal DNS

NEW QUESTION 181
You want to deploy VxRail, leveraging your existing VMware SSO domain.
What is the recommended method?

Deploy to an External vCenter

Deploy Embedded vCenter with Embedded PSC

Configure Embedded vCenter in Enhanced Linked Mode

Deploy External vCenter with no PSC

NEW QUESTION 182
An administrator physically installed the new nodes. Which two tasks must they complete before starting the deployment wizard? (Choose two.)

Upgrade the firmware to the appropriate version using iDRAC.

Validate the private management network VLAN.

Configure the iDRAC network settings.

Install the appropriate ESXi release using a VMware ISO.

NEW QUESTION 183
What scenario requires deploying a new VxRail cluster with a customer-managed vCenter server instead of a VxRail-managed vCenter?

The new VxRail cluster is a 2-node vSAN cluster.

The customer plans to manage an existing non-VxRail vSAN cluster in the same vCenter.

The customer plans to add an additional VxRail cluster to the same vCenter.

The new VxRail cluster is a dynamic node cluster using FC-attached storage.

NEW QUESTION 184
A managed services team is planning a four-node VxRail cluster to support a new customer with limited resources in the data center. Which statement describes the physical switch considerations that can support the design?

An OOB Management switch is required to support iDRAC management within the configuration.

VxRail network traffic uplinks and iDRAC management uplinks can be combined on the same TOR switches.

IPv6 Multicast technology must be supported by the TOR switches for manual node discovery.

A VDS must be preconfigured with an LACP dynamic LAG to support resource-intense VSAN traffic.

NEW QUESTION 185
Once a VxRail cluster has been acquired, what is the correct sequence of steps to deploy it?

NEW QUESTION 186
What is the correct sequence of steps to perform a RASR Factory Reset using an SD card?

NEW QUESTION 187
An implementation engineer is working with a customer to prepare an external vCenter Server for a new VxRail deployment with customer-supplied VDS.
What vCenter objects must exist for a successful VxRail deployment?

Datacenter, Cluster, and Custom VDS

Datacenter, VxRail Management user, and Custom VDS

Datacenter and VxRail Management user only

Datacenter, Cluster, and VxRail Management user

NEW QUESTION 188
Which VxRail Series is designed to support a VDI environment and requires a GPU card in each host?

S Series

V Series

G Series

P Series

NEW QUESTION 189
View the Exhibit.

You are reviewing a VxRail Pre-Installation Site Checklist.
What conclusion can be drawn about the VxRail deployment from the exhibit?

Top of Rack (ToR) switches will use two uplink ports

Upstream switches will have two ISLs

Two Top of Rack (ToR) switches will be used

Two Upstream switches will be used

NEW QUESTION 190
A VxRail cluster 4.7.xxx environment is managed by the internal vCenter Server. An implementation engineer plans to deploy a new VxRail cluster using the existing vCenter Server instance, then use the customer-supplied VDS to manage both VxRail clusters.
What must be done?

Migrate the internal vCenter Server to an external vCenter Server, then merge the PSC

Upgrade the VxRail version from 4.7.xxx to 7.0.000

Migrate the internal vCenter Server to an external vCenter Server, then upgrade the VxRail 4.7.xxx to 7.0.100

Upgrade the internal vCenter Server to version 7.0

NEW QUESTION 191
After finishing the rack and stack of a fully populated VxRail G560 chassis, in what sequence should the nodes be powered on?

Any order – sequence is not important

All four nodes at the same time

Must be in the following order: 4, 3, 2, 1

Must be in the following order: 1, 2, 3, 4

NEW QUESTION 192
You have determined that you need to execute a RASR factory upgrade of a VxRail v4.7.1xx node You download the RASR ISO from the Dell Support site.
What is the correct order of steps to finish the upgrade?